Returns the number of microseconds since the Maple board began running the current program. This number will overflow (go back to zero), after approximately 70 minutes.
Note
There are 1,000 microseconds in a millisecond, and 1,000,000 microseconds in a second.
Returns time (in microseconds) since the beginning of program execution.
On overflow, restarts at 0.
See: | millis() |
---|
unsigned int time;
void setup() {
}
void loop() {
SerialUSB.print("Time: ");
time = micros();
// prints time since program started
SerialUSB.println(time);
// wait a second so as not to send massive amounts of data
delay(1000);
}
License and Attribution
Portions of this page were adapted from the Arduino Reference Documentation, which is released under a Creative Commons Attribution-ShareAlike 3.0 License.